10tph TGM160 Grinding Mill in Indonesia

Place of use: Indonesia

Equipment: TGM160 Grinding Mill

Processed material: limestone

Capacity: 10t/h

Input size: 50mm

Output size: 200mesh

Limestone Mill High Efficiency, Large Capacity, 200-2500

Limestone can be directly processed into aggregated rock and burnt into unslaked lime which becomes slaked lime after its moisture & water absorption. The main content of slaked lime is Ca(OH)2. 1.Pendulum mill(R、HC、HCQ): It can grind coarse powder whose grain size is under 600 meshes, low investment cost, low energy consumption.get price

Mill (grinding) Wikipedia

OverviewGrinding machinesGrinding lawsTypes of grinding millsSee alsoExternal links

In materials processing a grinder is a machine for producing fine particle size reduction through attrition and compressive forces at the grain size level. See also crusher for mechanisms producing larger particles. In general, grinding processes require a relatively large amount of energy; for this reason, an experimental method to measure the energy used locally during milling with different machines was recently proposed. A typical type of fine grinder is the ball mill. A slightly inclined or horizontal rotget price

In materials processing a grinder is a machine for producing fine particle size reduction through attrition and compressive forces at the grain size level. See also crusher for mechanisms producing larger particles. In general, grinding processes require a relatively large amount of energy; for this reason, an experimental method to measure the energy used locally during milling with different machines was recently proposed. A typical type of fine grinder is the ball mill. A slightly inclined or horizontal rotating cylinder is partially filled with balls, usually stone or metal, which grind material to the necessary fineness by friction and impact with the tumbling balls. Ball mills normally operate with an approximate ball charge of 30%. Ball mills are characterized by their smaller (comparatively) diameter and longer length, and often have a length 1.5 to 2.5 times the diameter. The feed is at one end of the cylinder and the discharge is at the other. Ball mills are commonly used in the manufacture of Portland cement and finer grinding stages of mineral processing, one example being the Sepro tyre drive Grinding Mill. Industrial ball mills can be as large as 8.5 m (28 ft) in diameter with a 22 MW motor, drawing approximately 0.0011% of the total world's power (see List of countries by electricity consumption). However, small versions of ball mills can be found in laboratories where they are used for grinding sample material for quality assurance. The power predictions for ball mills typically use the following form of the Bond equation: $${\displaystyle E=10W\left({\frac {1}{\sqrt {P_{80}}}}-{\frac {1}{\sqrt {F_{80}}}}\right)\,}$$where • E is the energy (kilowatt-hours per metric or short ton)get price